Notifications
Clear all
apemberton
apemberton
Group: Registered
Joined: 2021/10/10
Active Member
1
Thanks for the input but perhaps I should have mentioned tha...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
As I've just got one of these to change from the E3D V6 hote...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
@dan-rogers, Thanks for your advice. Which slicer setting ar...

In forum How do I print this? (Printing help)

3 years ago
@dan-rogers Thanks for the tip about nozzle height. This I w...

In forum How do I print this? (Printing help)

3 years ago
Settings for a detailed PETG print?

In forum How do I print this? (Printing help)

3 years ago
I have performed my first prints of the delicate parts as ph...

In forum How do I print this? (Printing help)

3 years ago
Thanks for your replies. Flex would not be rigid enough for ...

In forum How do I print this? (Printing help)

3 years ago
Thanks folks, I will order a small amount of PETG and give i...

In forum How do I print this? (Printing help)

3 years ago
I am using a 0.2mm hardened steel nozzle for my modelling pr...

In forum Hardware, firmware and software help

3 years ago
Switching from PLA to ABS?

In forum How do I print this? (Printing help)

3 years ago
I have been investigating my problem and I think I have cure...

In forum Hardware, firmware and software help

3 years ago
Yes, I do cut off the end of the filament before inserting. ...

In forum Hardware, firmware and software help

3 years ago
Yes replacing a tube is what I have done - several times - a...

In forum Hardware, firmware and software help

3 years ago
Bulges in PTFE tube

In forum Hardware, firmware and software help

3 years ago
Share: