Notifications
Clear all
Antimatter
Skupina: Registrovaný
Přidal se: 2020/03/07
Active Member
1
| I grabbed a E3D X .6mm. Going to find myself some new model... | před 5 years | |
| @bobstro Thanks a ton! | před 5 years | |
| Best Nozzles for MK3S? | před 5 years | |
| I found some off amazon with good reviews with the MK3S. I w... | před 5 years | |
| Just the axis i was having issues with (Y). About halfway t... | před 5 years | |
| First print worked pretty great. Doing the Vase now about an... | před 5 years | |
| I have greased up the bearings a bit. and I turned off crash... | před 5 years | |
| @robert-rmm200 I did not grease as the instructions indicate... | před 5 years | |
| The motors themselves might not be locked up, the bearings c... | před 5 years | |
| Began with Y-Axis Failures during prints + Crash Detection -... | před 5 years |