Aniraf – Activité – Prusa3D Forum

Notifications

Clear all

Aniraf

Groupe: Enregistré

A(ont) rejoint: 2020/02/21

Trusted Member

	MK3S rebooting when MMU2S loads Dans le forum Hardware, firmware and software help	il y a 5 years
	@tim-m30 yep! Thanks!! Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Is there supposed to be a big hole in the side of the extrud... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Apparently the wires were reversed inside of the printer :/.... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Where is "Load filament - Load All" Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	OK, I'm getting this down! I'm pretty excited now. I've lear... Dans le forum How do I print this? (Printing help)	il y a 6 years
	There is another issue with the model where the "top" of the... Dans le forum How do I print this? (Printing help)	il y a 6 years
	@karl-herbert I tried to position it like that such that bot... Dans le forum How do I print this? (Printing help)	il y a 6 years
	@neil-t this is super helpful, I'll give this a try. Dans le forum How do I print this? (Printing help)	il y a 6 years
	New owner making bad prints Dans le forum How do I print this? (Printing help)	il y a 6 years

Page 3 / 3 Précédent

Statistiques du forum

585 Forums

67.9 K Sujets

476 K Messages

11 En-ligne

75.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé