Notifiche
Cancella tutti
andy.f
Gruppo: Registrato
Registrato: 2016/04/18
Active Member
1
|
Hi Stephan,
The filament goes in approx. 70mm.
Andy Nel forum Others (Archive) |
8 years fa | |
|
Unable To Load Filament Nel forum Others (Archive) |
8 years fa | |
|
Hi again,
Paolo:
I tried setting the 'Lift Z' parameter set... Nel forum Print tips (Archive) |
9 years fa | |
|
Guys,
Thanks for all your suggestions.
Paolo:
Thanks for d... Nel forum Print tips (Archive) |
9 years fa | |
|
Hi Paolo,
Here is a photo of 3 test prints (at the back) th... Nel forum Print tips (Archive) |
9 years fa | |
|
Hi Paolo,
You're right I have given conflicting information... Nel forum Print tips (Archive) |
9 years fa | |
|
Hi Paolo,
The box is 73 x 25 x 27mm.
The temperatures are ... Nel forum Print tips (Archive) |
9 years fa | |
|
Bumps on Walls of Print Nel forum Print tips (Archive) |
9 years fa | |
|
Guys,
Thanks for info, I thought I might have a problem wit... Nel forum Prusa i3 kit (Archive) |
9 years fa | |
|
How Far Down Fan Mount Should Filament Go? Nel forum Prusa i3 kit (Archive) |
9 years fa |