Notifications
Clear all
andy.f
Group: Registered
Joined: 2016/04/18
Active Member
1
|
Hi Stephan,
The filament goes in approx. 70mm.
Andy In forum Others (Archive) |
8 years ago | |
|
Unable To Load Filament In forum Others (Archive) |
8 years ago | |
|
Hi again,
Paolo:
I tried setting the 'Lift Z' parameter set... In forum Print tips (Archive) |
9 years ago | |
|
Guys,
Thanks for all your suggestions.
Paolo:
Thanks for d... In forum Print tips (Archive) |
9 years ago | |
|
Hi Paolo,
Here is a photo of 3 test prints (at the back) th... In forum Print tips (Archive) |
9 years ago | |
|
Hi Paolo,
You're right I have given conflicting information... In forum Print tips (Archive) |
9 years ago | |
|
Hi Paolo,
The box is 73 x 25 x 27mm.
The temperatures are ... In forum Print tips (Archive) |
9 years ago | |
|
Bumps on Walls of Print In forum Print tips (Archive) |
9 years ago | |
|
Guys,
Thanks for info, I thought I might have a problem wit... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
How Far Down Fan Mount Should Filament Go? In forum Prusa i3 kit (Archive) |
9 years ago |