Actividad
 
Avisos
Vaciar todo
Andy
Andy
Grupo: Registrado
Registrado: 2018/11/19
Eminent Member
2
Just received the replacement LCD display with the new encod...

En el foro Assembly and first prints troubleshooting

hace 5 years
I've managed to resolve all my problems, and I am really hap...

En el foro General discussion, announcements and releases

hace 5 years
This is a great tip, and one that I think will solve the iss...

En el foro General discussion, announcements and releases

hace 5 years
@david-h8 I tried a small squirt of WD40 and it loosened eno...

En el foro Assembly and first prints troubleshooting

hace 5 years
These are all good advice and I’m now onto my 18th hour of p...

En el foro Assembly and first prints troubleshooting

hace 5 years
@towlerg See the Underextrusion thread in setup/first print ...

En el foro General discussion, announcements and releases

hace 5 years
I too have the textured and smooth sheet, the differences we...

En el foro General discussion, announcements and releases

hace 5 years
I have both. I have had zero issues with the MK3 and the upg...

En el foro General discussion, announcements and releases

hace 5 years
@brad-w2 Fantastic! I think this was my issue too. I also no...

En el foro Assembly and first prints troubleshooting

hace 5 years
Agreed, but I’m unable to do this until Prusa get back to me...

En el foro Assembly and first prints troubleshooting

hace 5 years
@chris-b2 At this point I’m not even able to unload the fila...

En el foro Assembly and first prints troubleshooting

hace 5 years
@chris-b2 I’m 100% in agreement. I’ve some different Bowden ...

En el foro Assembly and first prints troubleshooting

hace 5 years
@chris-b2 Yeah my MK3 is superb with anything. The Mini is v...

En el foro Assembly and first prints troubleshooting

hace 5 years
@chris-b2 Have you tried some different filament? I’m using ...

En el foro Assembly and first prints troubleshooting

hace 5 years
Mine has now completely gone and I snapped one of the "arms"...

En el foro Assembly and first prints troubleshooting

hace 5 years
Cold pull is worth a shot as Sigfredo suggests if not alread...

En el foro Assembly and first prints troubleshooting

hace 5 years
@chris-b2 I’ve had similar amounts of time invested and the ...

En el foro Assembly and first prints troubleshooting

hace 5 years
@chris-b2 I did notice some dust and strands of filament (an...

En el foro Assembly and first prints troubleshooting

hace 5 years
@chris-b2 Are you able to pull the hot end down or notice an...

En el foro Assembly and first prints troubleshooting

hace 5 years
@jockspice Check out the “under extrusion” topic. Some of us...

En el foro General discussion, announcements and releases

hace 5 years
Página 1 / 2
Compartir: