Notifications
Clear all
andrew.r28
Groupe: Enregistré
A(ont) rejoint: 2018/06/01
Active Member
1
|
A few more 10+ ours prints and no problems.
Thank you all f... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
This morning I cleaned the block off after heating it up, th... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
I will double check. With the silicone sock on, my 11 hour p... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
I took it out, cleaned it and the rest of the hot end with a... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
Good idea about printing a mold and casting my own, but at t... Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
Where would one obtain said silicone sock? Dans le forum Hardware, firmware and software help |
il y a 6 years | |
|
Filament leaking Dans le forum Hardware, firmware and software help |
il y a 6 years |