Prusa3D Forum

Notifications

Clear all

andrew.r28

Group: Registered

Joined: 2018/06/01

Active Member

	A few more 10+ ours prints and no problems. Thank you all f... In forum Hardware, firmware and software help	6 years ago
	This morning I cleaned the block off after heating it up, th... In forum Hardware, firmware and software help	6 years ago
	I will double check. With the silicone sock on, my 11 hour p... In forum Hardware, firmware and software help	6 years ago
	I took it out, cleaned it and the rest of the hot end with a... In forum Hardware, firmware and software help	6 years ago
	Good idea about printing a mold and casting my own, but at t... In forum Hardware, firmware and software help	6 years ago
	Where would one obtain said silicone sock? In forum Hardware, firmware and software help	6 years ago
	Filament leaking In forum Hardware, firmware and software help	6 years ago

Forum Statistics

559 Forums

62.9 K Topics

443 K Posts

19 Online

67.7 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed