Prusa3D Forum

Notifications

Clear all

Andrew Meler

Skupina: PreRegistered

Přidal se: 2024/12/30

Název: Member

	Yes, the same GCode was used initially, but then I re-sliced... In forum General discussion, announcements and releases	před 11 months
	Bad PETG prints after software upgrade In forum General discussion, announcements and releases	před 11 months

Fórum Statistiky

595 Fóra

69.1 K Témata

483.5 K Příspěvky

14 Online

78.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed