Notifications
Clear all
André Lind
André Lind
Skupina: Registrovaný
Přidal se: 2019/10/15
Eminent Member
2
Yeah, it skips something like 70-150 lines of gcode and then...

In forum General discussion, announcements and releases

před 10 months
Replaced the stick on both machines but still get missing ex...

In forum General discussion, announcements and releases

před 10 months
Mid layer skips, this is getting really annoying!

In forum General discussion, announcements and releases

před 10 months
Both X and Y carriages where just as smooth as my other mach...

In forum Assembly and first prints troubleshooting

před 12 months
Super weird first layer

In forum Assembly and first prints troubleshooting

před 12 months
Weird artifacts on overhangs

In forum Input Shaper (MK4)

před 1 year
This issue has been solved, turned out to be a faulty nozzle...

In forum Input Shaper (MK4)

před 1 year
They advertise it “with input shaping” and it has just that....

In forum Input Shaper (MK4)

před 1 year
There was definitely something wrong with my nozzle, Prusa s...

In forum Assembly and first prints troubleshooting

před 1 year
Prusa is sending me a new nozzle, so hoping it solves it 🙂

In forum Assembly and first prints troubleshooting

před 1 year
I'm still having some serious issues on 5.0.0RCPolyTerra PLA...

In forum Input Shaper (MK4)

před 1 year
I'm in contact with support, cold pulls did not help either ...

In forum Assembly and first prints troubleshooting

před 1 year
Gone through the extruder now, increased/decreased tension, ...

In forum Assembly and first prints troubleshooting

před 1 year
I’ll check the extruder, thanks 🙏

In forum Assembly and first prints troubleshooting

před 1 year
a bit hard too see but I would say it suffers from the same ...

In forum Assembly and first prints troubleshooting

před 1 year
The test print from Prusa looked perfectly fine Was in conta...

In forum Assembly and first prints troubleshooting

před 1 year
So, I've checked and tightened the grub screws on both X and...

In forum Assembly and first prints troubleshooting

před 1 year
Got some print quality issues

In forum Assembly and first prints troubleshooting

před 1 year
Gaps on top layer

In forum Input Shaper (MK4)

před 1 year
There’s one more variable to this as well, we don’t actually...

In forum General discussion, announcements and releases

před 1 year
Stránka 1 / 2
Share: