Avisos
Vaciar todo
Ancientwolf
Ancientwolf
Grupo: Registrado
Registrado: 2016/10/01
Estimable Member
4
Strange banging at direction change...

En el foro PrusaSlicer

hace 5 years
Matt's S3D settings are night and day in difference, and are...

En el foro General discussion, announcements and releases

hace 8 years
You'll be glad you did. I havent had but one print lift and ...

En el foro Others (Archive)

hace 8 years
WD-40 is not a lubricant.

En el foro Prusa i3 kit (Archive)

hace 8 years
A few have managed a working method for overlaying a glass s...

En el foro Others (Archive)

hace 8 years
Didnt anybody notice he said at the start that his PINDA is ...

En el foro Assembly and first prints troubleshooting

hace 8 years
This started happening even earlier than that. It's filament...

En el foro Others (Archive)

hace 8 years
What are you going on about Nigel?

En el foro Others (Archive)

hace 8 years
I must have got lucky- I picked up both the RJZM-02-08 and t...

En el foro Hardware, firmware and software help

hace 8 years
I must have got lucky- I picked up both the RJZM-02-08 and t...

En el foro Hardware, firmware and software help

hace 8 years
Thanks Stephan!

En el foro Others (Archive)

hace 8 years
Okay, so Michele from the chat support gave me a hint, where...

En el foro Others (Archive)

hace 8 years
I haven't had a bad print from the Prusa Edition of Slic3r. ...

En el foro Print tips (Archive)

hace 8 years
The sheath on the one is smooth, hence press fit, vs the RJZ...

En el foro Improvements (Archive)

hace 8 years
Thats why I will stick with sheathed bearings as I described...

En el foro Improvements (Archive)

hace 8 years
As I mentioned in the improvements section, I came across: ...

En el foro Hardware, firmware and software help

hace 8 years
Bearings: RJZM-02-08 appears to be a good alternative?

En el foro Improvements (Archive)

hace 8 years
Searching the forum for 115200 yielded some results.

En el foro Software (Archive)

hace 8 years
SMH... Didnt even catch that... *sigh*

En el foro Print tips (Archive)

hace 8 years
Have you tried the Prusa Edition of Slic3r? Could solve all ...

En el foro Print tips (Archive)

hace 8 years
Página 1 / 7
Compartir: