Prusa3D Forum

Notifications

Clear all

Amutep

Skupina: Registrovaný

Přidal se: 2018/04/18

Active Member

	i dont know whats happen with the printer why i can print th... In forum Hardware, firmware and software help	před 5 years
	i dont know because the y axis is fine i think there is all ... In forum Hardware, firmware and software help	před 5 years
	P1 P2 to stupid to insert a picture 😀 In forum Hardware, firmware and software help	před 5 years
	hello now i tested printing from sd card normaly i print wit... In forum Hardware, firmware and software help	před 5 years
	Mk3 + s getting y crashs and layershifts firmware issue ? In forum Hardware, firmware and software help	před 5 years
	hello i have same noise with janbex pla sometimes. Extruder... In forum Others (Archive)	před 6 years
	hello thx i test it with slower speed printing. that make s... In forum How do I print this? (Printing help)	před 6 years
	hello no tht seam is ok i think the seam comes from that i ... In forum How do I print this? (Printing help)	před 6 years
	Re: Pla problem with cylindrical objects In forum How do I print this? (Printing help)	před 6 years
	Pla problem with cylindrical objects In forum How do I print this? (Printing help)	před 6 years

Fórum Statistiky

559 Fóra

62.9 K Témata

442.7 K Příspěvky

19 Online

67.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed