|
mk3s feeding issue En el foro How do I print this? (Printing help) |
hace 8 months |
|
got a few prints out with the standard temps but high tensio... En el foro How do I print this? (Printing help) |
hace 2 years |
|
it was doing it with the stock nozzle as well, that is why t... En el foro How do I print this? (Printing help) |
hace 2 years |
|
Just standard PLA through this printer. I can open it up and... En el foro How do I print this? (Printing help) |
hace 2 years |
|
nope, I made sure it was all good when I took the hot end ap... En el foro How do I print this? (Printing help) |
hace 2 years |
|
it spins fine, loosening way off had no change in the issue ... En el foro How do I print this? (Printing help) |
hace 2 years |
|
its the correct one, mostly because I put a MK3s+ one in fro... En el foro How do I print this? (Printing help) |
hace 2 years |
|
2 recent failed prints En el foro How do I print this? (Printing help) |
hace 2 years |
|
I tested the idler tension by loosening and then cranking th... En el foro How do I print this? (Printing help) |
hace 2 years |
|
Constant jamming, out of ideas for what to check En el foro How do I print this? (Printing help) |
hace 2 years |
|
Forgot I posted this. Thought I would come back and say this... En el foro How do I print this? (Printing help) |
hace 2 years |
|
It happens at all default settings with all prints. Picture ... En el foro How do I print this? (Printing help) |
hace 3 years |
|
perimeter doesnt stick will at smooth first layer height; ba... En el foro How do I print this? (Printing help) |
hace 3 years |
|
increasing my perimeters to .5mm fixed the issue and cut 30m... En el foro PrusaSlicer |
hace 3 years |
|
That makes sense, I will increase my perimeter width to comp... En el foro PrusaSlicer |
hace 3 years |
|
I’m using the .4mm layer height quality for the .8mm nozzle ... En el foro PrusaSlicer |
hace 3 years |
|
file is attached
that is.... annoying? I guess, that t... En el foro PrusaSlicer |
hace 3 years |
|
gap fill even though features are a multiple of extrusion wi... En el foro PrusaSlicer |
hace 3 years |
|
CHT Nozzle settings/increasing speed En el foro User mods - OctoPrint, enclosures, nozzles, ... |
hace 3 years |
|
Tore down the Y axis and redid it and it works fine now. I m... En el foro How do I print this? (Printing help) |
hace 3 years |
