|
mk3s feeding issue In forum How do I print this? (Printing help) |
10 months ago |
|
got a few prints out with the standard temps but high tensio... In forum How do I print this? (Printing help) |
2 years ago |
|
it was doing it with the stock nozzle as well, that is why t... In forum How do I print this? (Printing help) |
2 years ago |
|
Just standard PLA through this printer. I can open it up and... In forum How do I print this? (Printing help) |
2 years ago |
|
nope, I made sure it was all good when I took the hot end ap... In forum How do I print this? (Printing help) |
2 years ago |
|
it spins fine, loosening way off had no change in the issue ... In forum How do I print this? (Printing help) |
2 years ago |
|
its the correct one, mostly because I put a MK3s+ one in fro... In forum How do I print this? (Printing help) |
2 years ago |
|
2 recent failed prints In forum How do I print this? (Printing help) |
2 years ago |
|
I tested the idler tension by loosening and then cranking th... In forum How do I print this? (Printing help) |
2 years ago |
|
Constant jamming, out of ideas for what to check In forum How do I print this? (Printing help) |
2 years ago |
|
Forgot I posted this. Thought I would come back and say this... In forum How do I print this? (Printing help) |
2 years ago |
|
It happens at all default settings with all prints. Picture ... In forum How do I print this? (Printing help) |
3 years ago |
|
perimeter doesnt stick will at smooth first layer height; ba... In forum How do I print this? (Printing help) |
3 years ago |
|
increasing my perimeters to .5mm fixed the issue and cut 30m... In forum PrusaSlicer |
3 years ago |
|
That makes sense, I will increase my perimeter width to comp... In forum PrusaSlicer |
3 years ago |
|
I’m using the .4mm layer height quality for the .8mm nozzle ... In forum PrusaSlicer |
3 years ago |
|
file is attached
that is.... annoying? I guess, that t... In forum PrusaSlicer |
3 years ago |
|
gap fill even though features are a multiple of extrusion wi... In forum PrusaSlicer |
3 years ago |
|
CHT Nozzle settings/increasing speed In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
Tore down the Y axis and redid it and it works fine now. I m... In forum How do I print this? (Printing help) |
3 years ago |
