Prusa3D Forum

Notifications

Clear all

am-erik-a

Groupe: Enregistré

A(ont) rejoint: 2020/08/22

Active Member

	Smooth print platform surface? (for printing transparent mic... Dans le forum User mods - OctoPrint, ...	il y a 1 year
	Is the "elephant foot" defect occuring at the X mark in the ... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Hi, Together with some companies in Norway, we have experi... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Hi, I think an offset was used in this study: Mitkus-2020--I... Dans le forum Hardware, firmware and software help	il y a 3 years
	Interesting news! What is the light intensity (in mW/cm2) of... Dans le forum General discussion, announcements and releases	il y a 3 years
	What is the unit for the "uvSensorData" in the UV calibratio... Dans le forum Hardware, firmware and software help	il y a 4 years
	@conny Thanks for the answer! Then I guess I can rule out "r... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	For how many prints/hours can the resin be kept in the vat? Dans le forum Assembly and first prints troubleshooting	il y a 4 years

Statistiques du forum

559 Forums

62.9 K Sujets

443.1 K Messages

19 En-ligne

67.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé