Aktywność
 
Notifications
Clear all
Alyssa
Alyssa
Grupa: Zarejestrowany
Dołączył: 2021/05/28
Eminent Member
2
sorry, should've clarified. I meant I used Windex with PETG,...

In forum Assembly and first prints troubleshooting

3 years temu
Yeah, I don't think the issue is the sheet unfortunately, ma...

In forum Assembly and first prints troubleshooting

3 years temu
Yeah though, I tried that a slight bit, but was really unsuc...

In forum Assembly and first prints troubleshooting

3 years temu
Yeah, so actually I've done a couple prints recently and the...

In forum Assembly and first prints troubleshooting

3 years temu
Ahh okay, so that's as I figured. I live in Florida which is...

In forum Assembly and first prints troubleshooting

3 years temu
It seems like roughly the prints fail at around the same tim...

In forum Assembly and first prints troubleshooting

3 years temu
I did think that was the problem at first, so I changed back...

In forum Assembly and first prints troubleshooting

3 years temu
Print keeps lifting off bed after a while

In forum Assembly and first prints troubleshooting

3 years temu
Accidentally forgot to replace the print bed and printed on ...

In forum Hardware, firmware and software help

3 years temu
Accidentally forgot to replace the print bed and printed on ...

In forum Hardware, firmware and software help

3 years temu
So that's actually what's confusing, the issue isn't on the ...

In forum Assembly and first prints troubleshooting

3 years temu
Filament jamming and unable to drag fully, now stringing ser...

In forum Assembly and first prints troubleshooting

3 years temu
@diem Thank you for the help although fortunately I didn't h...

In forum Assembly and first prints troubleshooting

3 years temu
Update, so I just figured out what I had to do to get my new...

In forum Assembly and first prints troubleshooting

3 years temu
I just tried on my Cruzer Glide that I formatted as FAT32, b...

In forum Assembly and first prints troubleshooting

3 years temu
The Mini's definitely worth it. It's my first printer that I...

In forum Assembly and first prints troubleshooting

3 years temu
@ksweir I do agree with this, there's literally no reason it...

In forum Assembly and first prints troubleshooting

3 years temu
hi y'all, sorry for the long delay, was dead tired after the...

In forum Assembly and first prints troubleshooting

3 years temu
Very unfortunate news, it ended up failing even later at 87%...

In forum Assembly and first prints troubleshooting

3 years temu
@diem working on it as I type this, same print that failed a...

In forum Assembly and first prints troubleshooting

3 years temu
Strona 2 / 3
Share: