Prusa3D Forum

Notifications

Clear all

Alphabeta777

Skupina: Registrovaný

Přidal se: 2023/03/06

Active Member

	Agree with all the comments - been the biggest fan of Prusa ... In forum General discussion, announcements and releases	před 1 year
	TLC advice for my MK3S to improve layer lines? In forum Hardware, firmware and software help	před 1 year
	Calibration cube - how to correct steps? In forum Hardware, firmware and software help	před 1 year
	Hehheh, ludicrous really - put a bit of grease on the rods a... In forum Hardware, firmware and software help	před 2 years
	Good shout, but no joy! All looks fine to me...? In forum Hardware, firmware and software help	před 2 years
	Started layer shifting after only 4,500+ prints.... unaccept... In forum Hardware, firmware and software help	před 2 years
	Ah, good suggestions - no all stock basically, but good thou... In forum Hardware, firmware and software help	před 2 years
	Printer printing 20mm too far to the right vs Prusaslicer? In forum Hardware, firmware and software help	před 2 years

Fórum Statistiky

579 Fóra

65.4 K Témata

457.4 K Příspěvky

28 Online

72.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed