Prusa3D Forum

Notifications

Clear all

Alphabeta777

Group: Registered

Joined: 2023/03/06

Active Member

	Agree with all the comments - been the biggest fan of Prusa ... In forum General discussion, announcements and releases	1 year ago
	TLC advice for my MK3S to improve layer lines? In forum Hardware, firmware and software help	1 year ago
	Calibration cube - how to correct steps? In forum Hardware, firmware and software help	1 year ago
	Hehheh, ludicrous really - put a bit of grease on the rods a... In forum Hardware, firmware and software help	1 year ago
	Good shout, but no joy! All looks fine to me...? In forum Hardware, firmware and software help	1 year ago
	Started layer shifting after only 4,500+ prints.... unaccept... In forum Hardware, firmware and software help	1 year ago
	Ah, good suggestions - no all stock basically, but good thou... In forum Hardware, firmware and software help	2 years ago
	Printer printing 20mm too far to the right vs Prusaslicer? In forum Hardware, firmware and software help	2 years ago

Forum Statistics

565 Forums

63.5 K Topics

446 K Posts

21 Online

68.8 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed