Prusa3D Forum

Notifications

Clear all

AllTheWay

Grupa: Zarejestrowany

Dołączył: 2020/07/11

Active Member

	Does anyone have any ideas? In forum How do I print this? (Printing help)	4 years temu
	Ok, just did and no change. I'm confused a little as to wha... In forum How do I print this? (Printing help)	4 years temu
	I tried some purge filament that I had for rainy days and di... In forum How do I print this? (Printing help)	4 years temu
	-Default temp settings for Prusament PLA via PrusaSlicer. -... In forum How do I print this? (Printing help)	4 years temu
	You're absolutely right, my bad. MK3S, Prusament Silver PLA... In forum How do I print this? (Printing help)	4 years temu
	Won't extrude without a little pressure In forum How do I print this? (Printing help)	4 years temu
	@karl-herbert I appreciate the reply. I can't send you a pm ... In forum Hardware, firmware and software help	4 years temu
	@charles-h13 Hasn’t arrived yet. Something held up on the sh... In forum Hardware, firmware and software help	4 years temu
	Full Bear upgrade and considering swapping hotend In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

565 Fora

63.8 K Tematy

447.5 K Posty

21 Online

69.5 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte