Čeština
Fóra
Uživatelé
Allen8355
Aktivita
 
Notifications
Clear all
Allen8355
Allen8355
Skupina: Registrovaný
Přidal se: 2017/01/25
Estimable Member
4
Profile Aktivita
Getting Slic3r Prusa Edition on Octoprint

In forum Software (Archive)

 před 8 years
Correction. The original PEI sheet included on my recent MK2...

In forum Others (Archive)

 před 8 years
I did the same thing. Its good it doesn't damage anything.

In forum Others (Archive)

 před 8 years
Yes please let use know how it goes. By the way, just print...

In forum Prusa i3 kit (Archive)

 před 8 years
If its not square now is the time to do that. Get on a step ...

In forum Prusa i3 kit (Archive)

 před 8 years
So the frustration with PEI has continued despite exact Z le...

In forum Prusa i3 kit (Archive)

 před 8 years
I had the same non-sticking problem and was frustrated like ...

In forum Assembly and first prints troubleshooting

 před 8 years
I cleaned the bed with acetone and raised the z axis a bit a...

In forum Prusa i3 kit (Archive)

 před 8 years
"On my squares negative value actually raises the bed, and p...

In forum Assembly and first prints troubleshooting

 před 8 years
Thanks. I will try your suggestions. As you can see from my...

In forum Prusa i3 kit (Archive)

 před 8 years
I measured the thickness and most are pretty close to 0.2mm ...

In forum Prusa i3 kit (Archive)

 před 8 years
I wanted to post a picture as well. This is ...

In forum Prusa i3 kit (Archive)

 před 8 years
How To Remove The PEI?

In forum Prusa i3 kit (Archive)

 před 8 years
Thank you all as I was loosing my mind getting this all adju...

In forum Assembly and first prints troubleshooting

 před 8 years
O.K. Thanks. That makes sense. I guess something must have ...

In forum Others (Archive)

 před 8 years
Color Filament Question

In forum Others (Archive)

 před 8 years
Stránka 10 / 10
Share: