Activity
 
Notifications
Clear all
alidaf
alidaf
Group: Registered
Joined: 2021/09/03
Trusted Member
3
Thanks, that gives me some relief at least. I'll swap it out...

In forum Hardware, firmware and software help

9 months ago
Faulty cartridge?

In forum Hardware, firmware and software help

9 months ago
Not damaged, just loosened up quite a bit. I have them in IK...

In forum How do I print this? (Printing help)

1 year ago
It's been a while but I've gone into my settings and these a...

In forum How do I print this? (Printing help)

1 year ago
Octoprint is a massive help for me running and monitoring 7 ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Well done, but you've missed the point! I have somehow manag...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
I know this is an old thread but the issue still exists. I h...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
I have them off already but the alarms must override the fee...

In forum Hardware, firmware and software help

2 years ago
Adjust MINTEMP setting.

In forum Hardware, firmware and software help

2 years ago
Reading through the spreadsheet again, some of the Klicky pa...

In forum How do I print this? (Printing help)

2 years ago
I just built the LDO 350 kit with the SB, keeping the CW1. I...

In forum How do I print this? (Printing help)

2 years ago
You are most welcome. I think you have the same problem as m...

In forum How do I print this? (Printing help)

2 years ago
@robert-14 Yeah, it really has warped a lot. Apart from some...

In forum How do I print this? (Printing help)

2 years ago
I think that whatever the prevailing advice on such things a...

In forum How do I print this? (Printing help)

2 years ago
@robert-14 I was using a MK3 in an IKEA Platsa cabinet , so ...

In forum How do I print this? (Printing help)

2 years ago
I don't think mine was. I am interested but I tend to go all...

In forum How do I print this? (Printing help)

2 years ago
You brute! Voron test cube RIP 😬. I've run tests in engineer...

In forum How do I print this? (Printing help)

2 years ago
@thejiral, @netpackrat. And here is the before and after... ...

In forum How do I print this? (Printing help)

2 years ago
I'm printing the LDO version of the 2.4R2. This particular c...

In forum How do I print this? (Printing help)

2 years ago
@thejiral, @netpackrat. Cooling seems to be doing the trick....

In forum How do I print this? (Printing help)

2 years ago
Page 1 / 4
Share: