Prusa3D Forum

Notifications

Clear all

Alex_NL

Groupe: Enregistré

A(ont) rejoint: 2022/09/15

Active Member

	Yes! This works! And now I know what mistake I made.. it's a... Dans le forum PrusaSlicer	il y a 2 years
	Hi, Thanks for the links (yeah the first ones had me puzzled... Dans le forum PrusaSlicer	il y a 2 years
	MMU style printing without an MMU (manual swapping the filam... Dans le forum PrusaSlicer	il y a 2 years
	Thanks for that! I also couldn't figure it out 🙂 Dans le forum Hardware, firmware and software help	il y a 2 years
	I downloaded the file but I see little difference. What slic... Dans le forum PrusaSlicer	il y a 2 years
	First layer at 0.1mm and fix some small artefacts on the out... Dans le forum PrusaSlicer	il y a 2 years
	Thanks for you reply! I will include the project file next t... Dans le forum PrusaSlicer	il y a 2 years
	Hi, Yup it turned out to be this setting. At the risk of sou... Dans le forum PrusaSlicer	il y a 2 years
	Why doesn't it accept 0.3 as a height range modifier? Dans le forum PrusaSlicer	il y a 2 years
	Hi, thanks for your reply; I'd go with the first picture but... Dans le forum PrusaSlicer	il y a 3 years
	IF you click on the photo you will see the whole image.. i t... Dans le forum PrusaSlicer	il y a 3 years
	What orientation would you print this? Dans le forum PrusaSlicer	il y a 3 years
	Anyone know what this Z axis sound means? Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Oh wow.. great, thanks so much! Will give this a print first... Dans le forum PrusaSlicer	il y a 3 years
	I looked for this but it seems like the blockers work on bot... Dans le forum PrusaSlicer	il y a 3 years
	Thanks for your reply. I attached the project.. I am curious... Dans le forum PrusaSlicer	il y a 3 years
	Possible to place supports only on the inside of a tube? Dans le forum PrusaSlicer	il y a 3 years

Statistiques du forum

585 Forums

68.4 K Sujets

479 K Messages

10 En-ligne

76.4 K Membres

Le dernier des messages: Anyone using the Bondtech LGX Shortcut? Notre nouveau membre: Camster Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé