Alec – Attività – Prusa3D Forum

Notifiche

Cancella tutti

Alec

Gruppo: Registrato

Registrato: 2020/05/28

Eminent Member

	Hi guys, Sorry for the late reply. I am still not able to ge... Nel forum Hardware, firmware and software help	4 years fa
	Hi Rick, I had a similar issue with the xyz calibration aft... Nel forum Hardware, firmware and software help	4 years fa
	@mrschultz, The light blinks sometimes, but never goes fully... Nel forum Hardware, firmware and software help	5 years fa
	Yes I did both but they did not resolve any issue. A suggest... Nel forum Hardware, firmware and software help	5 years fa
	@mrschultz I tried this but it did not work (lowering the pr... Nel forum Hardware, firmware and software help	5 years fa
	No problem. Thank you very much for all the input! Nel forum Hardware, firmware and software help	5 years fa
	The Z-axis is 320 mm. Nel forum Hardware, firmware and software help	5 years fa
	Hi, Thank you for the reply! When calibrating, should the nu... Nel forum Hardware, firmware and software help	5 years fa
	Hi Olaf, You right, they are not shortened correctly. Thanks... Nel forum Hardware, firmware and software help	5 years fa
	Hi, I checked the PINDA out and it works according to this... Nel forum Hardware, firmware and software help	5 years fa
	I did the adjustments but the it doesn't help 🙁 Any other t... Nel forum Hardware, firmware and software help	5 years fa
	Hi Robert, Thank you for the tip! I will check it out asap. ... Nel forum Hardware, firmware and software help	5 years fa
	xyz calibration failed. bed calibration point was not found Nel forum Hardware, firmware and software help	5 years fa

Pagina 2 / 2 Precedente

Statistiche Forum

566 Forum

63.2 K Discussioni

444.4 K Post

20 Online

68.2 K Utenti

Post recenti: Printer started printing offset mid print. Ultimo utente registrato: etiennep Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso