Alec – Activité – Prusa3D Forum

Notifications

Clear all

Alec

Groupe: Enregistré

A(ont) rejoint: 2020/05/28

Eminent Member

	Hi guys, Sorry for the late reply. I am still not able to ge... Dans le forum Hardware, firmware and software help	il y a 4 years
	Hi Rick, I had a similar issue with the xyz calibration aft... Dans le forum Hardware, firmware and software help	il y a 4 years
	@mrschultz, The light blinks sometimes, but never goes fully... Dans le forum Hardware, firmware and software help	il y a 5 years
	Yes I did both but they did not resolve any issue. A suggest... Dans le forum Hardware, firmware and software help	il y a 5 years
	@mrschultz I tried this but it did not work (lowering the pr... Dans le forum Hardware, firmware and software help	il y a 5 years
	No problem. Thank you very much for all the input! Dans le forum Hardware, firmware and software help	il y a 5 years
	The Z-axis is 320 mm. Dans le forum Hardware, firmware and software help	il y a 5 years
	Hi, Thank you for the reply! When calibrating, should the nu... Dans le forum Hardware, firmware and software help	il y a 5 years
	Hi Olaf, You right, they are not shortened correctly. Thanks... Dans le forum Hardware, firmware and software help	il y a 5 years
	Hi, I checked the PINDA out and it works according to this... Dans le forum Hardware, firmware and software help	il y a 5 years
	I did the adjustments but the it doesn't help 🙁 Any other t... Dans le forum Hardware, firmware and software help	il y a 5 years
	Hi Robert, Thank you for the tip! I will check it out asap. ... Dans le forum Hardware, firmware and software help	il y a 5 years
	xyz calibration failed. bed calibration point was not found Dans le forum Hardware, firmware and software help	il y a 5 years

Page 2 / 2 Précédent

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

21 En-ligne

68.1 K Membres

Le dernier des messages: Xl extruder stops Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé