Čeština
Fóra
Uživatelé
Alec
Aktivita
 
Notifications
Clear all
Alec
Alec
Skupina: Registrovaný
Přidal se: 2020/05/28
Eminent Member
2
Profile Aktivita
Hi guys, Sorry for the late reply. I am still not able to ge...

In forum Hardware, firmware and software help

 před 4 years
Hi Rick, I had a similar issue with the xyz calibration aft...

In forum Hardware, firmware and software help

 před 4 years
@mrschultz, The light blinks sometimes, but never goes fully...

In forum Hardware, firmware and software help

 před 5 years
Yes I did both but they did not resolve any issue. A suggest...

In forum Hardware, firmware and software help

 před 5 years
@mrschultz I tried this but it did not work (lowering the pr...

In forum Hardware, firmware and software help

 před 5 years
No problem. Thank you very much for all the input!

In forum Hardware, firmware and software help

 před 5 years
The Z-axis is 320 mm.

In forum Hardware, firmware and software help

 před 5 years
Hi, Thank you for the reply! When calibrating, should the nu...

In forum Hardware, firmware and software help

 před 5 years
Hi Olaf, You right, they are not shortened correctly. Thanks...

In forum Hardware, firmware and software help

 před 5 years
Hi, I checked the PINDA out and it works according to this...

In forum Hardware, firmware and software help

 před 5 years
I did the adjustments but the it doesn't help 🙁 Any other t...

In forum Hardware, firmware and software help

 před 5 years
Hi Robert, Thank you for the tip! I will check it out asap. ...

In forum Hardware, firmware and software help

 před 5 years
xyz calibration failed. bed calibration point was not found

In forum Hardware, firmware and software help

 před 5 years
Stránka 2 / 2
Share: