Prusa3D Forum

Notifications

Clear all

alamatth

Groupe: Enregistré

A(ont) rejoint: 2020/02/01

Active Member

	Ok, similar experience with support chat. Pics and videos, ... Dans le forum Hardware, firmware and software help	il y a 11 months
	I’m having a similar issue. Did you get it figured out? Dans le forum Hardware, firmware and software help	il y a 11 months
	When I’ve had stringing issues like that it was either low q... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	@apromain I’ve considered rolling back as well. I’ve though... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	@magician-144 2.5mm ID isn’t available anywhere in the US. ... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	@nimaim I actually have one of those for RC car bodies. Tha... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	@magician-144 Thanks. What diameter tube did you go with? Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	MMU2S PTFE Tube Direction Dans le forum Assembly and first prints troubleshooting	il y a 5 years

Statistiques du forum

559 Forums

63.1 K Sujets

444 K Messages

20 En-ligne

68 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé