Prusa3D Forum

Notifications

Clear all

ajsmcs

Group: Registered

Joined: 2018/04/24

Active Member

	Out of curiosity, why? In forum User mods - OctoPrint, enclosures, nozzles, ...	5 years ago
	There is already a thermistor table within the stock prusa f... In forum User mods - OctoPrint, enclosures, nozzles, ...	5 years ago
	UPDATE: I dug through the code again, and it turns out that... In forum User mods - OctoPrint, enclosures, nozzles, ...	6 years ago
	Just to clarify - the only thing you did was wire directly t... In forum User mods - OctoPrint, enclosures, nozzles, ...	6 years ago
	I'm in the the exact same boat as you. I'm partway through ... In forum Hardware, firmware and software help	6 years ago
	FIXED. I updated to the new firmware, and that apparently f... In forum Hardware, firmware and software help	6 years ago
	XYZ Calibration Fails at 3rd Cal Point In forum Hardware, firmware and software help	6 years ago

Forum Statistics

565 Forums

63.6 K Topics

446.1 K Posts

20 Online

68.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed