|
Re: Extruder Motor Damper? In forum Prusa i3 kit (Archive) |
8 years ago |
|
I think you really need to slow down the print on the small ... In forum Prusa i3 kit (Archive) |
8 years ago |
|
It sounds like you need to adjust your PINDA probe height.
... In forum Prusa i3 kit (Archive) |
8 years ago |
|
I think there is advice for this problem in the second post ... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Why couldn't we just auto level BEFORE heating the bed? OR e... In forum Prusa i3 kit (Archive) |
8 years ago |
|
No, it wasn't occurring at a specific height, but it affecte... In forum Prusa i3 kit (Archive) |
8 years ago |
|
What are your thoughts on the ruby nozzle? Do you feel it co... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Since you are using the standard Prusa Slic3r, it prints a s... In forum Software (Archive) |
8 years ago |
|
I have no experience with this, I have just been thinking ab... In forum Others (Archive) |
8 years ago |
|
The newer versions of Slic3r support both single and MMUs.
... In forum Others (Archive) |
8 years ago |
|
There are a quite few things that could cause this. You rea... In forum Others (Archive) |
8 years ago |
|
You slicer has a section for "Start GCode" This is where y... In forum Software (Archive) |
8 years ago |
|
Yes. That would cause the problem.
This is a standard set ... In forum Others (Archive) |
8 years ago |
|
Please check the way you attached the stepper to the RAMBO b... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Have you tried calibrating your extruder? In forum Prusa i3 kit (Archive) |
8 years ago |
|
Prusa Mk2S, PLA@215/60, Simplify3D.
I've been using the sam... In forum Prusa i3 kit (Archive) |
8 years ago |
|
To summarize your post, that the rest of the model looks fin... In forum Prusa i3 kit (Archive) |
8 years ago |
|
So, you used "Original Prusa i3 MK2 with ZHop", "0.15 OPTIMA... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Try Mesh Mixer as pre-slicing work. In forum Awesome prints (Hall Of Fame) |
8 years ago |
|
It is hard to tell from your description, but if you are pri... In forum Print tips (Archive) |
8 years ago |
