AJS – Activité – Prusa3D Forum

Notifications

Clear all

AJS

Groupe: Enregistré

A(ont) rejoint: 2017/01/10

Noble Member

	Extruder stops extruding filament. (Works for a while then s... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Have you tried some "cold pulls" to see if there is a clog i... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Since this sounds like a firmware issues, I would do a facto... Dans le forum Assembly and first prints troubleshooting	il y a 8 years
	Did you slice this yourself? Or is it pre-sliced? Is the c... Dans le forum Print tips (Archive)	il y a 8 years
	Under "Print Settings" -> "Advanced" -> "infill Extrus... Dans le forum Others (Archive)	il y a 8 years
	Please try the steps found here: If that does not help, p... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I was using the Prusa 3D Slic3r, but ive just started a prin... Dans le forum Others (Archive)	il y a 8 years
	This printer is very capable of sharp corners on all sides. ... Dans le forum Print tips (Archive)	il y a 8 years
	Okay ive reprinted the Prusa Frog straight from the SD card ... Dans le forum Others (Archive)	il y a 8 years
	I uploaded the picture to imgur and posted the link to it in... Dans le forum Others (Archive)	il y a 8 years
	You should try to set your Live Z "approximately correct" us... Dans le forum Others (Archive)	il y a 8 years
	You need to loosen the motor (step 21) so that you can tight... Dans le forum Others (Archive)	il y a 8 years
	Yeah, check the list of things found in the post I provided ... Dans le forum Others (Archive)	il y a 8 years
	And it looks like you could use some improvement on your Liv... Dans le forum Others (Archive)	il y a 8 years
	Yeah, check the list of things found in the post I provided ... Dans le forum Others (Archive)	il y a 8 years
	A list of possible extruder issues can be found here: E... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	You are not by chance "double clicking" for the one fan prom... Dans le forum Assembly and first prints troubleshooting	il y a 8 years
	Your images did not post, so I really don't have any idea wh... Dans le forum Others (Archive)	il y a 8 years
	Hard to tell from your post, but it sounds like you have a s... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Did you check the material guide?: There it is recommended... Dans le forum Others (Archive)	il y a 8 years

Page 23 / 51 Précédent Suivant

Statistiques du forum

585 Forums

68.3 K Sujets

478.3 K Messages

10 En-ligne

76.2 K Membres

Le dernier des messages: Is Advanced Filtration supposed to smell weird Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé