AJS – Activity – Prusa3D Forum

Notifications

Clear all

AJS

Group: Registered

Joined: 2017/01/10

Noble Member

	Extruder stops extruding filament. (Works for a while then s... In forum Prusa i3 kit (Archive)	8 years ago
	Have you tried some "cold pulls" to see if there is a clog i... In forum Prusa i3 kit (Archive)	8 years ago
	Since this sounds like a firmware issues, I would do a facto... In forum Assembly and first prints troubleshooting	8 years ago
	Did you slice this yourself? Or is it pre-sliced? Is the c... In forum Print tips (Archive)	8 years ago
	Under "Print Settings" -> "Advanced" -> "infill Extrus... In forum Others (Archive)	8 years ago
	Please try the steps found here: If that does not help, p... In forum Prusa i3 kit (Archive)	8 years ago
	I was using the Prusa 3D Slic3r, but ive just started a prin... In forum Others (Archive)	8 years ago
	This printer is very capable of sharp corners on all sides. ... In forum Print tips (Archive)	8 years ago
	Okay ive reprinted the Prusa Frog straight from the SD card ... In forum Others (Archive)	8 years ago
	I uploaded the picture to imgur and posted the link to it in... In forum Others (Archive)	8 years ago
	You should try to set your Live Z "approximately correct" us... In forum Others (Archive)	8 years ago
	You need to loosen the motor (step 21) so that you can tight... In forum Others (Archive)	8 years ago
	Yeah, check the list of things found in the post I provided ... In forum Others (Archive)	8 years ago
	And it looks like you could use some improvement on your Liv... In forum Others (Archive)	8 years ago
	Yeah, check the list of things found in the post I provided ... In forum Others (Archive)	8 years ago
	A list of possible extruder issues can be found here: E... In forum Prusa i3 kit (Archive)	8 years ago
	You are not by chance "double clicking" for the one fan prom... In forum Assembly and first prints troubleshooting	8 years ago
	Your images did not post, so I really don't have any idea wh... In forum Others (Archive)	8 years ago
	Hard to tell from your post, but it sounds like you have a s... In forum Prusa i3 kit (Archive)	8 years ago
	Did you check the material guide?: There it is recommended... In forum Others (Archive)	8 years ago

Page 23 / 51 Prev Next

Forum Statistics

585 Forums

68.3 K Topics

478.3 K Posts

13 Online

76.1 K Members

Latest Post: Performance difference? Pi0 to Pi4 upgrade, USB or GPIO/Einsy interface Our newest member: ArtiVIVO Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed