Čeština
Fóra
Uživatelé
agentc0re
Aktivita
 
Notifications
Clear all
agentc0re
agentc0re
Skupina: Registrovaný
Přidal se: 2016/11/29
Active Member
1
Profile Aktivita
Replaced PINDA Probe with NPN NO LJ12A3-4-Z/BX-5V but calibr...

In forum Others (Archive)

 před 8 years
David & Jeff, thank you for the reply. Here is a pictur...

In forum Others (Archive)

 před 8 years
Here's a screen shot of my speed settings in slicer.

In forum Others (Archive)

 před 8 years
Why does my print look like this?

In forum Others (Archive)

 před 8 years
I tried quite mode and my x-axis stopped moving all in one d...

In forum Print tips (Archive)

 před 8 years
High Power. Should I try quite mode?

In forum Print tips (Archive)

 před 8 years
Which direction is the layer shift occurring? X, Y or both? ...

In forum Print tips (Archive)

 před 8 years
Really bad layer shifting

In forum Print tips (Archive)

 před 8 years
The induction probes do not require a ferrous metal; the cur...

In forum Prusa i3 kit (Archive)

 před 8 years
FWIW I will have some MK42 beds in a week or less. I am hav...

In forum Prusa i3 kit (Archive)

 před 8 years
Thank you so much Jeff. I will give all of that a try!

In forum Others (Archive)

 před 8 years
Prints aren't turning out to be that great in spots

In forum Others (Archive)

 před 8 years
Could be antivirus?

In forum Software (Archive)

 před 8 years
make sure if you have antivirus that it's not blocking it fr...

In forum Software (Archive)

 před 8 years
Im choosing the correct serial port. I can tell in device m...

In forum Software (Archive)

 před 8 years
Can't upgrade firmware on my minirambo

In forum Software (Archive)

 před 8 years
Is MK2 Open Source?

In forum Others (Archive)

 před 8 years
Share: