|
Help - My printer is skewed! In forum Others (Archive) |
9 years ago |
|
Similar to Patrik's recommendation, I'd suggest looking at a... In forum Print tips (Archive) |
9 years ago |
|
I've used Nylon 680 from filaments.ca before. Printed parts... In forum Print tips (Archive) |
9 years ago |
|
Thanks all,
Some great ideas there. One more question, are... In forum Print tips (Archive) |
9 years ago |
|
Thanks,
I haven't tried ABS yet. I jumped from PLA to PETG ... In forum Print tips (Archive) |
9 years ago |
|
Oh, just to add, my go to filament is PETG but it gets a bit... In forum Print tips (Archive) |
9 years ago |
|
High temp filament help needed In forum Print tips (Archive) |
9 years ago |
|
Hi,
Thanks for the info.
Not meaning to appear stupid but... In forum Others (Archive) |
9 years ago |
|
Hi,
I use eSun PETG exclusively now.
I managed to reduce ... In forum Others (Archive) |
9 years ago |
|
High Power Mode Print Speed In forum Others (Archive) |
9 years ago |
|
Hi,
Thanks for the reply.
No, ZHop is not enabled.
I'm be... In forum Others (Archive) |
9 years ago |
|
One more thing,
I was running in quiet mode and when things... In forum Others (Archive) |
9 years ago |
|
Hi,
This was from an SD Card.
The GCode must be ok. I lit... In forum Others (Archive) |
9 years ago |
|
Strange Occurence In forum Others (Archive) |
9 years ago |
|
Hi all,
I have been printing exclusively with PETG at 240/9... In forum Others (Archive) |
9 years ago |
|
Well, the heating element comes in at 5.2 Ohms and the rail ... In forum Others (Archive) |
9 years ago |
|
Ok Guys.
I've done some experimentation and got some intere... In forum Others (Archive) |
10 years ago |
|
Now that could be the issue.
I used 10% in fill and the pri... In forum Others (Archive) |
10 years ago |
|
Not sure. The air stream is over the nozzle. Wouldn't this c... In forum Others (Archive) |
10 years ago |
|
Too cool!! In forum Others (Archive) |
10 years ago |
