Notifications
Clear all
adam.f2
adam.f2
Group: Registered
Joined: 2016/01/04
Eminent Member
2
Okay. Was able today to just fool around with the printer, a...

In forum Print tips (Archive)

10 years ago
Yes, it was 0.2mm for the first layer on my print compared t...

In forum Print tips (Archive)

10 years ago
Okay, I got NP++ and opened them both up to compare. The fai...

In forum Print tips (Archive)

10 years ago
I dug through them all earlier, and they appeared to be an e...

In forum Print tips (Archive)

10 years ago
I started Adalinda, and stopped it at 10% as I don't have en...

In forum Print tips (Archive)

10 years ago
Is there a good small one to try on there with infill? I c...

In forum Print tips (Archive)

10 years ago
Layer separation and bad infill, but perfect when hollow?

In forum Print tips (Archive)

10 years ago
I haven't tried varying the temperature yet, but I am please...

In forum Print tips (Archive)

10 years ago
Bruce.w and adam.f2, I have found a great design for replaci...

In forum Prusa i3 kit (Archive)

10 years ago
Will give it a shot in a bit, and see how it goes. Thanks fo...

In forum Print tips (Archive)

10 years ago
I saw your print with the Woodfill. Very nice, actually have...

In forum Print tips (Archive)

10 years ago
I'm going to chime in on this one as well. Same overall exp...

In forum Prusa i3 kit (Archive)

10 years ago
Any tips for printing with Wood, Bronze or Laybrick?

In forum Print tips (Archive)

10 years ago
Oddly enough, the frame was twisted last week when I was act...

In forum Prusa i3 kit (Archive)

10 years ago
High in the middle on calibration

In forum Prusa i3 kit (Archive)

10 years ago
Sorry for the delayed response, was tied up with work and un...

In forum Prusa i3 kit (Archive)

10 years ago
Thanks for the photo, that helped quite a bit. I rechecked ...

In forum Prusa i3 kit (Archive)

10 years ago
I haven't done anything yet, but everything is exactly as it...

In forum Prusa i3 kit (Archive)

10 years ago
That looks amazing. Those types of masks have always been co...

In forum Awesome prints (Hall Of Fame)

10 years ago
Extruder body not lined up with pulley and tube

In forum Prusa i3 kit (Archive)

10 years ago
Page 1 / 2
Share: