Čeština
Fóra
Uživatelé
AbeFM
Aktivita
 
Notifications
Clear all
AbeFM
AbeFM
Skupina: PrusaLink-beta
Přidal se: 2017/12/07
Název: Member
Profile Aktivita
There's "even" then there's "even". When you say the first l...

In forum Assembly and first prints troubleshooting

 před 7 years
I will get days of great printing, then days of nothing stic...

In forum Assembly and first prints troubleshooting

 před 7 years
Where is the "fixed" firmware? It's based on which (i.e. no...

In forum Assembly and first prints troubleshooting

 před 7 years
A small improvement I'd suggest (I guess this came from usin...

In forum Others (Archive)

 před 7 years
On the mesh leveling issue: just posted this if you're brav...

In forum Others (Archive)

 před 7 years
I'm getting first layers issues, and assumed part of it WAS ...

In forum Assembly and first prints troubleshooting

 před 7 years
My newly arrived MK3 is also clicking. Primarily when prehea...

In forum Hardware, firmware and software help

 před 7 years
With the changes as described, it certainly works. I find t...

In forum Others (Archive)

 před 7 years
Suggestion: Add the the top post that there is no current CU...

In forum General discussion, announcements and releases

 před 7 years
I took your suggestion Darren and dropped infill speed. I se...

In forum Others (Archive)

 před 7 years
I'm using Cura 3.1.0 and it works good. I have 2 issues thou...

In forum General discussion, announcements and releases

 před 7 years
Very excited about this. Will be trying it soon. Did you ju...

In forum Others (Archive)

 před 7 years
Ah, you're in luck, sort of. I had that EXACT issue on somet...

In forum Others (Archive)

 před 7 years
You may as well just drop acceleration or jerk settings - wh...

In forum Others (Archive)

 před 7 years
Stránka 20 / 20
Share: