Notifications
Clear all
abbreviations
abbreviations
Group: Registered
Joined: 2020/06/12
Eminent Member
2
@jsw Is it normal that the side strips fall off after a few ...

In forum Hardware, firmware and software help

4 years ago
@jsw The print had finished a few hours earlier. So yes the ...

In forum Hardware, firmware and software help

4 years ago
@jsw Thanks for your post. No I did not use any utensils to...

In forum Hardware, firmware and software help

4 years ago
RE: Cracked smooth PEI sheet with ABS

In forum Hardware, firmware and software help

4 years ago
@herbert I would like that, but I suspect it was an issue on...

In forum Hardware, firmware and software help

4 years ago
@herbert Thanks for you answer. It was fully cooled down whe...

In forum Hardware, firmware and software help

4 years ago
Cracked smooth PEI sheet with ABS

In forum Hardware, firmware and software help

4 years ago
@bobstro I have always felt that the best products emanate f...

In forum Hardware, firmware and software help

4 years ago
@nikolai-r I guess you are right. So my feature request woul...

In forum Hardware, firmware and software help

4 years ago
@bobstro Overclocking and flashing custom firmware is not re...

In forum Hardware, firmware and software help

4 years ago
@zoltan How does that not stifle contributions to the code b...

In forum Hardware, firmware and software help

4 years ago
@zoltan If you want to contribute code you need to test it f...

In forum Hardware, firmware and software help

4 years ago
I just had the same issue with the hot end pressing into the...

In forum Hardware, firmware and software help

4 years ago
I tried to grease the all the rods but it did not solve the ...

In forum Hardware, firmware and software help

4 years ago
I will try that. But why does the resistance only happen in ...

In forum Hardware, firmware and software help

4 years ago
X-Axis internal position wrong at boot.

In forum Hardware, firmware and software help

4 years ago
In before the moderator approved the post... I solved it by ...

In forum Hardware, firmware and software help

4 years ago
X-Axis self test fail

In forum Hardware, firmware and software help

4 years ago
Will this print well with MMU and soluble support?

In forum How do I print this? (Printing help)

4 years ago
Share: