Prusa3D Forum

Notifications

Clear all

aasbakk

Grupa: Zarejestrowany

Dołączył: 2025/03/22

Active Member

	Thanks 😀 Ill look into this In forum Prusa Connect & PrusaLink	5 months temu
	I downloaded the previous Prusalink version (0.7.2). This wo... In forum Prusa Connect & PrusaLink	5 months temu
	I have the same issue on my Mk3S+. Bought a RPi Zero 2W, and... In forum Prusa Connect & PrusaLink	5 months temu
	The magnet doesn’t stick at the motor housing cover with the... In forum Assembly and first prints troubleshooting	6 months temu
	Haven’t tried magnet only as I’m a little afraid of how to g... In forum Assembly and first prints troubleshooting	6 months temu
	I tried also with a smaller boss design with a smaller magne... In forum Assembly and first prints troubleshooting	6 months temu
	Extruder indicator wheel not turning In forum Assembly and first prints troubleshooting	6 months temu
	Sorry about that. Newbie both on 3D printing and on this for... In forum Hardware, firmware and software help	6 months temu
	Thanks again I had did a bad assembly where heat break and n... In forum Hardware, firmware and software help	6 months temu
	Extruded wheel indicator not turning In forum Hardware, firmware and software help	6 months temu
	Thank you for your suggestions. I’ll try and fix it during n... In forum Hardware, firmware and software help	7 months temu

Statystyki Forum

585 Fora

68.4 K Tematy

479 K Posty

11 Online

76.4 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte