Prusa3D Forum

Notifications

Clear all

aasbakk

Groupe: Enregistré

A(ont) rejoint: 2025/03/22

Active Member

	Thanks 😀 Ill look into this Dans le forum Prusa Connect & PrusaLink	il y a 5 months
	I downloaded the previous Prusalink version (0.7.2). This wo... Dans le forum Prusa Connect & PrusaLink	il y a 5 months
	I have the same issue on my Mk3S+. Bought a RPi Zero 2W, and... Dans le forum Prusa Connect & PrusaLink	il y a 5 months
	The magnet doesn’t stick at the motor housing cover with the... Dans le forum Assembly and first prints troubleshooting	il y a 6 months
	Haven’t tried magnet only as I’m a little afraid of how to g... Dans le forum Assembly and first prints troubleshooting	il y a 6 months
	I tried also with a smaller boss design with a smaller magne... Dans le forum Assembly and first prints troubleshooting	il y a 6 months
	Extruder indicator wheel not turning Dans le forum Assembly and first prints troubleshooting	il y a 6 months
	Sorry about that. Newbie both on 3D printing and on this for... Dans le forum Hardware, firmware and software help	il y a 6 months
	Thanks again I had did a bad assembly where heat break and n... Dans le forum Hardware, firmware and software help	il y a 6 months
	Extruded wheel indicator not turning Dans le forum Hardware, firmware and software help	il y a 6 months
	Thank you for your suggestions. I’ll try and fix it during n... Dans le forum Hardware, firmware and software help	il y a 7 months

Statistiques du forum

585 Forums

68.4 K Sujets

479 K Messages

10 En-ligne

76.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé