Prusa3D Forum

Notifications

Clear all

aasbakk

Skupina: Registrovaný

Přidal se: 2025/03/22

Active Member

	Thanks 😀 Ill look into this In forum Prusa Connect & PrusaLink	před 7 months
	I downloaded the previous Prusalink version (0.7.2). This wo... In forum Prusa Connect & PrusaLink	před 7 months
	I have the same issue on my Mk3S+. Bought a RPi Zero 2W, and... In forum Prusa Connect & PrusaLink	před 7 months
	The magnet doesn’t stick at the motor housing cover with the... In forum Assembly and first prints troubleshooting	před 8 months
	Haven’t tried magnet only as I’m a little afraid of how to g... In forum Assembly and first prints troubleshooting	před 8 months
	I tried also with a smaller boss design with a smaller magne... In forum Assembly and first prints troubleshooting	před 8 months
	Extruder indicator wheel not turning In forum Assembly and first prints troubleshooting	před 8 months
	Sorry about that. Newbie both on 3D printing and on this for... In forum Hardware, firmware and software help	před 8 months
	Thanks again I had did a bad assembly where heat break and n... In forum Hardware, firmware and software help	před 8 months
	Extruded wheel indicator not turning In forum Hardware, firmware and software help	před 8 months
	Thank you for your suggestions. I’ll try and fix it during n... In forum Hardware, firmware and software help	před 8 months

Fórum Statistiky

595 Fóra

69.1 K Témata

483.4 K Příspěvky

13 Online

78.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed