|
There may be multiple problems, but my Mini's MINDA probe co... En el foro Hardware, firmware and software help |
hace 5 years |
|
Chat/support mentioned they'd talked to 3 or 4 people the sa... En el foro Hardware, firmware and software help |
hace 5 years |
|
Unfortunately, after a successful long print, my Mini is now... En el foro Hardware, firmware and software help |
hace 5 years |
|
🤔 (I followed the instructions of my PEI textured sheet tha... En el foro Hardware, firmware and software help |
hace 5 years |
|
I did a full turn with the nozzle because of this text in th... En el foro Hardware, firmware and software help |
hace 5 years |
|
Still no luck. 😕 I adjusted the nozzle. I ran the PID c... En el foro Hardware, firmware and software help |
hace 5 years |
|
The 60mm circle you provided is 2 layers high. I let the pri... En el foro Hardware, firmware and software help |
hace 5 years |
|
Status: Bed cleaned thoroughly. Extrusion measured to be clo... En el foro Hardware, firmware and software help |
hace 5 years |
|
Thanks so much for the continued advice!! I'll try your sugg... En el foro Hardware, firmware and software help |
hace 5 years |
|
Here are the results. The circle at 100mm seemed to go pret... En el foro Hardware, firmware and software help |
hace 5 years |
|
I'll try your cal circle tonight and using soap/water. I had... En el foro Hardware, firmware and software help |
hace 5 years |
|
Thanks! I did not have mesh bed leveling set to 7x7 -- it wa... En el foro Hardware, firmware and software help |
hace 5 years |
|
Here's the bottom of the print as requested. En el foro Hardware, firmware and software help |
hace 5 years |
|
I tried to print the Benchy boat and it became unstuck for s... En el foro Hardware, firmware and software help |
hace 5 years |
|
The nozzle was an exact replacement (same 0.4mm nozzle as wa... En el foro Hardware, firmware and software help |
hace 5 years |
|
Standard .4mm nozzle (purchased from Prusa) I'm using the st... En el foro Hardware, firmware and software help |
hace 5 years |
|
Unable to determine what's causing this issue En el foro Hardware, firmware and software help |
hace 5 years |
