Notifications
Clear all
__Chris__
Group: Registered
Joined: 2019/02/03
Active Member
1
| My printer has sat idle for 2 months, bought a replacement f... | 4 years ago | |
| @fromprusa The filament sensor and alignment is what I've be... | 4 years ago | |
| OK, so I added the LED, (with resistor) and it's been very "... | 4 years ago | |
| @joantabb Hi, it looks like you didn't use a resistor on the... | 4 years ago | |
| beyond frustrated | 4 years ago | |
| I just figured out the fix. The custom G code M862.3 P "[pri... | 4 years ago | |
| xyz calibration (not automatic) | 4 years ago | |
|
I3 MK3S filament sensor mechanical problems In forum Hardware, firmware and software help |
5 years ago |