Notifications
Clear all
2002superhawk
Skupina: Registrovaný
Přidal se: 2019/05/16
Active Member
1
| @del-wilson It is fixed. I needed to step away from it for a... | před 6 years | |
| thanks, i'll check that! | před 6 years | |
| Filament not extruding | před 6 years | |
| So I took Tim’s advice and checked the gears. One was canted... | před 6 years | |
| Thanks for this! while I am "pretty sure" that these are OK ... | před 6 years | |
| so in short... everything 😊 that's what i expected. I'm ... | před 6 years | |
| The steel plate is definitely off when I'm testing. I've bee... | před 6 years | |
| Thanks for the info on the emulator also! I appreciate that,... | před 6 years | |
| Thank you for the reply! it doesn't fail until after finish... | před 6 years | |
| Failed XYZ Calibration | před 6 years |