Notifications
Clear all
2002superhawk
Group: Registered
Joined: 2019/05/16
Active Member
1
| @del-wilson It is fixed. I needed to step away from it for a... | 6 years ago | |
| thanks, i'll check that! | 6 years ago | |
| Filament not extruding | 6 years ago | |
| So I took Tim’s advice and checked the gears. One was canted... | 6 years ago | |
| Thanks for this! while I am "pretty sure" that these are OK ... | 6 years ago | |
| so in short... everything 😊 that's what i expected. I'm ... | 6 years ago | |
| The steel plate is definitely off when I'm testing. I've bee... | 6 years ago | |
| Thanks for the info on the emulator also! I appreciate that,... | 6 years ago | |
| Thank you for the reply! it doesn't fail until after finish... | 6 years ago | |
| Failed XYZ Calibration | 6 years ago |