Čeština
Fóra
Uživatelé
0mib
Aktivita
 
Notifications
Clear all
0mib
0mib
Skupina: Registrovaný
Přidal se: 2021/09/26
Active Member
1
Profile Aktivita
Error code 2 when exporting a post-processed file?

In forum Hardware, firmware and software help

 před 2 years
Thanks for all the responses, I knew this method was a possi...

In forum How do I print this? (Printing help)

 před 4 years
That's some pretty impressive adhesion. I'll try doing a sta...

In forum How do I print this? (Printing help)

 před 4 years
Can I print multiple colors at the same layer?

In forum How do I print this? (Printing help)

 před 4 years
I clean the bed pretty regularly, I use a supermarket brand ...

In forum How do I print this? (Printing help)

 před 4 years
Just switched from inland PLA Lite to regular inland PLA, no...

In forum How do I print this? (Printing help)

 před 4 years
Just read up on bridging flow, speed and temp as well so I'l...

In forum How do I print this? (Printing help)

 před 4 years
The support material article was very helpful and informativ...

In forum How do I print this? (Printing help)

 před 4 years
Strange lines (artifacts?) on bottom of rounded pieces

In forum How do I print this? (Printing help)

 před 4 years
This may be the wrong place to ask about this but I'm still ...

In forum Hardware, firmware and software help

 před 4 years
I apologize for the late response, I've been away from my co...

In forum Hardware, firmware and software help

 před 4 years
First layer problems or something else?

In forum Hardware, firmware and software help

 před 4 years
Can't even complete a first layer test?

In forum Assembly and first prints troubleshooting

 před 4 years
How to clean solids off bed?

In forum Assembly and first prints troubleshooting

 před 4 years
Share: