Notifications
Clear all
Filament change with OctoPrint?
I have been using OctoPrint with my mini for a few weeks with no issues. I did not have to adjust any settings that I would configure for any other printer.
I did, however, encounter a problem today, I was printing something that had a filament change in the .gcode. The Mini pasued at the correct point, but it would not allow me to load the next color (Octoprint lock-out screen).
Has anyone encountered this same behavior? If so, is there a known work-around?
I guess I'm back to printing from USB when I have filament changes...
Posted : 23/04/2020 5:18 pm
RE: Filament change with OctoPrint?
It is a known issue ( https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/362 ) but unfortunately I'm not aware of any workaround for the issue.
Posted : 23/04/2020 5:46 pm
kermur liked