Wipe tower not available for muti-material supports? - PrusaSlicer

RE:

RGB — Thu, 11 Dec 2025 08:58:09 +0000

Merci beaucoup, j'attendais cette information depuis très longtemps 😊 👍 👍

Thank you very much, I have been waiting for this information for a very long time 😊 👍 👍

RE: Wipe tower not available for muti-material supports?

Frank — Wed, 03 Dec 2025 23:14:03 +0000

Thanks - I figured that out.

RE: Wipe tower not available for muti-material supports?

BaconFase — Wed, 03 Dec 2025 23:01:37 +0000

Basically, with the stock slicer if you don't have "Top contact Z distance" set to zero then you can't set a specific support extruder while having a wipe tower at the same time.

Wipe tower not available for muti-material supports?

Frank — Tue, 02 Dec 2025 23:00:37 +0000

I have a Voron 2.4/300 with the MissChanger mod and PS 2.9.4. I want to print a model in PETG using PLA supports, but when I select 'supports everywhere', I get an error message saying "the wipe tower currently supports non-soluble supports only if they are printed with the current extruder without triggering a tool change..."

This doesn't make a lot of sense to me - it implies that the wipe tower *does* support soluble supports, but why would the slicer care whether the support filament is soluble or not, and why would I use a wipe tower in the first place if I wasn't doing toolhead changes?

Can someone please explain this to me? TIA

Frank