Notifications
Clear all

Support of PrinterOS?  

  RSS
Jeggo
(@jeggo)
Active Member
Support of PrinterOS?

Hello,

is there a possibility for PrinterOS in future version of PrusaSlicer?

PrinterOS is supported by Cura (since V3?). I own a printer, that is only accessible via USB thumbdrive or PrinterOS.

CU

Jens

Napsal : 07/02/2021 11:39 am
cwbullet
(@cwbullet)
RE: Support of PrinterOS?

I would put in a request on GitHub.  

--------------------
Chuck H
3D Printer Review Blog

Napsal : 07/02/2021 3:22 pm
Share: