Stamp
Any chance of getting a stamp feature in PrusaSlicer?
RE: Stamp
First of all welcome.
Secondly, this is a user to user forum. If you want to make a feature request then that needs to be done over on the Prusa Slicer github site. That is located here https://github.com/prusa3d/PrusaSlicer/issues?q=is%3Aissue+is%3Aopen+sort%3Aupdated-desc
Please read the submission guidelines before making a request though and be sure to do a thorough search with as many potential keywords first as with over 1900 open issues its quite likely to already be there.
With that out the way, it depends what you mean by 'stamp'. The request is not very clear. It will need to be better explained for an official request to even be considered. That is one way the forums are useful. To solicit advice and get feedback on putting together a suitable request. It may be that its already possible to do it in the software.
For example you can already use a negative volume with any model to add a 'stamp' into another model for instance. This could be adding a date, a logo etc. Basically anything you model up can be used. You could use the same model to add a raised 'stamp' to a part too by adding it type part (although such things are better done at the CAD stage rather than afterwards).
RE: Stamp
I stand corrected.