Spiral infill instead of concentric possible?
I'm currently printing what is effectively a lot of flat rings & concentric keeps wasting time alternating between an extrusion at the outside of the ring then an extrusion on the inside of the ring. Is there a way to do a spiral infill going from the outer edge of the ring to the inner?
Best Answer by NotJannet:
Okay, looking on the prusa page for infills led me to try the seemingly single infil pattern I've never used before.
Archimedean chords
Which does, in fact, make spiral infill on my parts. Ultimately it only took half an hour off the part I'm currently looking at, but it's good to know.
RE: Spiral infill instead of concentric possible?
Okay, looking on the prusa page for infills led me to try the seemingly single infil pattern I've never used before.
Archimedean chords
Which does, in fact, make spiral infill on my parts. Ultimately it only took half an hour off the part I'm currently looking at, but it's good to know.