Notifications
Clear all
PrusaSlicer Crashing On Slice
Anybody else crashing when you slice a model on Ubuntu? I can't seem to get this model to slice when I try and go below the default 0.2mm layer height settings.
Posted : 29/09/2019 11:46 pm
RE: PrusaSlicer Crashing On Slice
How many errors are reported when you import the model? A bad model will <sometimes> crash P.Slicer ... you can try exporting a repaired model and loading the repaired version back in; and if that doesn't do it, use the NetFabb interface to do the repair.
This post was modified 5 years ago by --
Posted : 30/09/2019 4:07 am
Topic starter
answered:
RE: PrusaSlicer Crashing On Slice
@tim-m30
Thanks for the info. I didn't know about Netfabb. The model had 107 errors. I ran it through Netfabb, but I'm still only able to get it down to 0.15mm layer height. Maybe I'm trying incompatible settings? I'm very new to PrusaSlicer and 3D printing in general.
Posted : 30/09/2019 11:44 am