Notifications
Clear all
PrusaSlicer 2.8 Paint-on Support Block, don't block
Good morning everyone,
I have a problem with this feature. Basically if I decide to paint with the (red) option to block the creation of a support at that point the slicer still creates it.
Have u some idea about it?
Posted : 26/08/2024 9:24 am
RE: PrusaSlicer 2.8 Paint-on Support Block, don't block
There are still grey overhangs visible in your first picture. Save, zip and post your slicer project, this way everybody can see what you did and make better suggestions...
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Posted : 26/08/2024 10:35 am